RP-HPLC purity raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-01-29 and is reviewed periodically as new material appears.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by RP-HPLC | Area percentage of the main peak |
| Identity confirmation | Electrospray ionization mass spectrometry | Observed mass compared with the theoretical value near 751.9 Da |
| Recommended dry storage | -20 °C, desiccated | -80 °C for multi-year archival material |
| Solution handling | Prepare fresh; avoid long storage | Sterile filtration reduces microbial load |
| Common synonyms | TKPRPGP; TP-7 | Sequence code and laboratory designation used interchangeably |
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Enzymatic stability motivates the extra three residues at the carboxyl end. Native tuftsin is cleaved quickly by circulating aminopeptidases and carboxypeptidases, which limits its duration of action and its usefulness as a tool compound. Extending the chain with proline-rich segments is a common design tactic because proline constrains the backbone and slows proteolysis. The same Pro-Gly-Pro motif appears in other Russian-developed peptides of the era. Whether the full seven-residue chain is required for activity, or whether it acts mainly as a prodrug releasing tuftsin, remains unresolved.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Quantification in biological matrices relies on liquid chromatography coupled to tandem mass spectrometry with stable-isotope internal standards. Low plasma concentrations and adsorption to container surfaces both complicate measurement. Solid-phase extraction is often needed to reduce matrix interference before injection. Reported limits of quantification differ widely between laboratories, which makes direct comparison of pharmacokinetic results difficult and limits meta-analysis.
Peptide bonds are vulnerable to protease attack, and Selank is no exception. Measured half-life in serum is short, on the order of minutes in several reports, which explains why intranasal administration is the common route described in the literature. Absorption across the nasal mucosa partially bypasses first-pass hepatic metabolism. Quantitative data on human bioavailability remain limited and are difficult to compare across studies.
Lyophilised material kept dry at minus 20 degrees Celsius or colder is the most stable form, and suppliers commonly state a shelf life of two years or more under those conditions. Once dissolved, degradation accelerates through hydrolysis and deamidation, particularly at alkaline pH or elevated temperature. Working solutions are usually divided into single-use aliquots to avoid repeated freeze-thaw cycles. The choice of reconstitution solvent affects both stability and the ionic strength of the final preparation.
=== 7 April === An Iraqi national, identified as Abbas Abuthar Witwit, died in a hospital in Luhansk due to injuries sustained while fighting as a member of the Wagner Group in Bakhmut the previous day, in what is believed to be the first confirmed case of a Middle East native to have died fighting in the war. His death was confirmed by Wagner's head Yevgeny Prigozhin, who said he had been recruited from a Russian jail, on 1 June.
A macrophage-activating factor (MAF) is a lymphokine or other receptor based signal that primes macrophages towards cytotoxicity to tumors, cytokine secretion, or clearance of pathogens. Similar molecules may cause development of an inhibitory, regulatory phenotype. A MAF can also alter the ability of macrophages to present MHC I antigen, participate in Th responses, and/or affect other immune responses. MAFs act typically in combination to produce a specific phenotype.
The International Supply Chain Education Alliance (ISCEA) is a certifying body. Founded in 2003 and currently holding over 100,000 members, ISCEA has its World HQ office in Beachwood, OH, USA and regional offices in LATAM, EMEA and APAC. ISCEA is the governing body for the Ptak Prize. Besides Certified Supply Chain Manager (CSCM) certification, ISCEA has developed several professional certification programs that include: Certified Supply Chain Analyst (CSCA), Certified Lean Master (CLM), Certified RFID Supply Chain Manager (RFIDSCM), Certified Demand Driven Planner (CDDP), Certified HealthCare Supply Chain Analyst (CHSCA); and Certified Lean Six Sigma Yellow Belt (CLSSYB), Green Belt (CLSSGB) and Black Belt (CLSSBB).
Sources: en.wikipedia.org
== M == Maillard reaction Madelung synthesis Malaprade reaction, Periodic acid oxidation Malonic ester synthesis Mannich reaction Markó–Lam deoxygenation Markovnikov's rule, Markownikoff rule, Markownikow rule Marschalk reaction Martinet dioxindole synthesis McDougall monoprotection McFadyen–Stevens reaction McMurry reaction Meerwein arylation Meerwein–Ponndorf–Verley reduction Meisenheimer rearrangement Meissenheimer complex Menshutkin reaction Metal-ion-catalyzed σ-bond rearrangement Mesylation Merckwald asymmetric synthesis Metallo-ene reaction Methylation Meyer–Hartmann reaction Meyer reaction Meyer synthesis Meyer–Schuster rearrangement Michael addition Michael addition, Michael system Michael condensation Michaelis–Arbuzov reaction Midland Alpine borane reduction Mignonac reaction Milas hydroxylation of olefins Minisci reaction Mislow–Evans rearrangement Mitsunobu reaction Miyaura borylation Modified Wittig-Claisen tandem reaction Molisch's test Mozingo reduction Mukaiyama aldol addition (Mukaiyama reaction) Mukaiyama hydration Myers' asymmetric alkylation
==== United States ==== In July 2025, the US Food and Drug Administration (FDA) formally recommended that the Drug Enforcement Administration (DEA) classify 7-OH-MIT as a controlled substance. This action was publicized to not be targeting Mitragyna speciosa leaf powder itself. Despite claims by marketers for products that contain 7-OH-MIT that they can be used to treat anxiety and pain, the drug is not approved by the FDA for any medical use or as a food supplement.
=== Names === In 2013, trastuzumab emtansine was approved in the United States with the generic name "ado-trastuzumab emtansine", rather than the original United States Adopted Name (USAN) issued in 2009, "trastuzumab emtansine". Trastuzumab is the anti-HER2 antibody; emtansine refers to the linker-drug (SMCC-DM1). The "ado-" prefix was added at the request of the FDA to help prevent dispensing errors. During preclinical development and clinical trials, the drug was also known as trastuzumab-DM1 or trastuzumab-MCC-DM1 (after the codename for emtansine), both abbreviated T-DM1, and by the codename PRO132365.
==== Policy Interventions ==== Banning non-therapeutic antibiotics in agriculture (e.g., European Union's 2006 growth promoter ban). Incentivizing development of new antibiotics and alternatives (e.g., vaccines, bacteriophages).
Sources: en.wikipedia.org
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.
A reported purity value reflects the share of the main peak in one chromatographic run and says nothing about identity. Confirming that the expected sequence is present requires a separate measurement such as mass spectrometry. Purity and identity are distinct questions.
A mass spectrum reports the molecular masses present in a sample and shows whether they match the value expected for selank, near 751.9 Da. It also flags common artifacts such as truncation or adduct formation. It does not establish correct stereochemistry or complete sequence order on its own.
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.